Kenwood NEXEDGE NX-200 Function Reference page 424

15 GPS
15.2 GPS Position Display
Displaying the Location Information
The transceiver enters GPS Position Display Mode if the GPS Position Display key is pressed or GPS Position Display is
selected by pressing the Menu key while the transceiver is in standby mode.
For Portable, the transceiver automatically switches between the latitude and longitude display and the altitude display
approximately every 5 sec while in GPS Position Display Mode. Pressing the Menu ([
GPS Position Display Mode.
For Mobile,the transceiver automatically switches among the latitude display, the longitude display, and the altitude display
approximately every 5 sec while in GPS Position Display Mode. Pressing the Menu ([
GPS Position Display Mode.
Note
• The transceiver cannot enter GPS Position Display Mode if the display that appears in GPS Position Display Mode is not configured.
• Pressing and holding the Menu ([ ]) or [*] key pauses the alternation of the automatic display. Pressing and holding the Menu ([ ])
or [*] key again resumes alternation of the automatic display. Also, the alternation of the automatic display can be paused or resumed
even if the Left key is pressed
FUNC (K)/Ver 4.00
Latitude and longitude
5 seconds later
Altitude
5 seconds later
Latitude
5 seconds later
Longitude
5 seconds later
Altitude
5 seconds later
]), Right/Home or [*] key aborts
]), Right/Home or [*] key aborts
CONTENTS INDEX 390