Kenwood NEXEDGE NX-200 Function Reference page 551

APPENDIX
Available Functions for the PF Keys
Function Name
Site Up (Continuous)
Speaker Attenuation
(Portable only)
Squelch Level
Squelch Off
Squelch Off Momentary
Stack
Status (FleetSync/NXDN)
Talk Around
Telephone Disconnect
FUNC (K)/Ver 4.00
Pressing and holding the Site Up key causes the site number to be
increased in steps of 1 every 100 ms. (Refer to
Be Used (Site Lock/ Site Select) on page
Temporarily attenuates the volume level of the speaker microphone. This
function can only be assigned to the PF 1 and PF 2 keys on a
microphone. (Refer to Temporarily Reducing the Volume Level of the
Speaker Microphone (Speaker Attenuation) (Portable Only) on page
Enters Squelch Level Mode. In Squelch Level Mode, the Squelch level
can be changed. (Refer to Adjusting the Reception Sensitivity of the
Transceiver (Squelch Level) on page
Note
For NX-200S/ NX-300S, this function cannot be assigned.
In an Analog Conventional system, the transceiver opens squelch and
unmutes the speaker. (Refer to
(Squelch Off) on page 251.)
In an NXDN Conventional system, the transceiver resets the matching
state of RAN code and Optional Signaling and resets muting upon
detection of an NXDN frame. (Refer to
(Squelch Off) on page 112.)
In an Analog Conventional system, the transceiver opens squelch and
disables muting while the Squelch Off Momentary key is pressed and
held. (Refer to Temporarily Disabling the Squelch (Squelch Off) on page
251.)
In an NXDN Conventional system,the transceiver resets the matching
state of RAN code and Optional Signaling and deactivates muting upon
detection of an NXDN frame while the Squelch Off Momentary key is
pressed and held. (Refer to Temporarily Disabling the Squelch (Squelch
Off) on page 112.)
Enters Stack Mode. While the transceiver is in Stack Mode, the data,
such as call records, Status Messages, and Short Messages, stored in
the stack memory of the transceiver can be viewed or cleared.
Note
For NX-200S/ NX-300S, this function cannot be assigned.
The transceiver enters Status Mode. In Status Mode, a Status Message
can be sent by a user selecting a status configured in the FleetSync
Status List or NXDN Status List, or directly entering a Status number.
(Refer to 8.9 Sending and Receiving a Status Message (Status Call) on
page 150, 12.6 Sending and Receiving a Status Message (Status Call) on
page 323.)
Note
For NX-200S/ NX-300S, this function cannot be assigned.
Toggles the Talk Around between enabled and disabled.
Sends the terminating signal (DTMF Code #) if the transceiver is
connected to the telephone line of an LTR Trunking system. (Refer to
11.5 Connecting to a Public Switched Telephone Network (PSTN)
(Telephone Interconnect) on page
Description
9.16 Locking the Site to
236.)
253.)
Temporarily Disabling the Squelch
Temporarily Disabling the Squelch
290.)
Available System
NXDN Trunking System
ALL
95.)
Analog Conventional System
Analog Conventional System
NXDN Conventional System
Analog Conventional System
NXDN Conventional System
ALL
ALL
Analog Conventional System
NXDN Conventional System
LTR Trunking System
LTR Trunking System
CONTENTS INDEX
*1
517