Kenwood NEXEDGE NX-200 Function Reference page 342

12 FleetSync
12.3 Transmitting/ Receiving a PTT ID
PTT ID Pause can be enabled or disabled and PTT ID Pause Time can be configured using KPG-111D/ DN. PTT ID Pause
can be configured for each Conventional Group and LTR Trunking system.
Configuration using KPG-111D/ DN
• Configuring the PTT ID Pause to be enabled or disabled (
• Configuring the PTT ID Pause Time (
Restricting the Transmission of the PTT ID in Talk Around
(Restricted ID in Talk Around)
Restricted ID in Talk Around is a function to disable the PTT ID transmission while Talk Around is enabled even if the PTT
switch is pressed or released.
This function is available when PTT ID is not required such as when directly communicating with other transceivers.
Note
This function can be only used in an Analog Conventional system.
Configuration using KPG-111D/ DN
Configuring the Restricted ID in Talk Around to be enabled or disabled (
Sending the Received Unit ID from the Communication Port (Unit ID Serial Output)
Unit ID Serial Output allows the transceiver to send the received Fleet and ID from the transceiver's communication port
when the transceiver receives the PTT ID.
With the Unit ID Serial Output enabled, the dispatcher can monitor and control in real time transceivers that are
transmitting.
Note
To use Unit ID Serial Output, the "Data" or "Data + GPS Data Output" must be assigned to the communication port of the transceiver.
Configuration using KPG-111D/ DN
Configuring the Unit ID Serial Output (
FUNC (K)/Ver 4.00
See
FPRG 8.10.6 Common Page 4 Tab)
See
FPRG 8.10.6 Common Page 4 Tab)
See
FPRG 8.3.4 Page 2 Tab, 8.7.16 PTT ID Pause)
See FPRG 8.11.1 Conventional Tab)
CONTENTS INDEX 308