Status Message Stack; Status Message On Data Zone-Ch/Gid - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.6 Sending and Receiving a Status Message (Status Call)
Remote Kill
The transceiver is disabled and no operations can be done when the transceiver receives the Remote Kill status (Status
87). However, the configuration data can be written to the transceiver using KPG-111D/ DN.
Whether to accept the received Remote Kill status can be configured using KPG-111D/ DN. (
General 1 Tab > n Stun/Kill Status Validation)
Statuses 90 to 92
These statuses are used to command or reset the Stun.
These statuses allow the transceiver to command or reset the Stun regardless of the Stun status of the receiving
transceiver.
Statuses 93 to 94
These status numbers are used to respond to the Stun status of the transceiver when receiving the RSTM (Request
Status).

Status Message Stack

Status Message Stack is the function to store a Status Message in the stack memory. A maximum of 15 Status Messages
can be stored in the stack memory.
If a message is stored, the "
enters Stack Mode. (Refer to
Note
• A maximum of 15 messages (Status Messages and Short Messages) can be stored in the stack memory.
• This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Status Message Stack (

Status Message on Data Zone-CH/GID

Status Message on Data Zone-CH/GID allows the transceiver to automatically change the channel to Data Zone-channel
or GID to send the Status Message.
The transceiver automatically changes the channel to Data Zone-channel or GID to send the Status Message. The
transceiver restores the last Zone-channel or GID when the transmission ends. Status Message on Data Zone-CH/GID
can be used to send data on a specific channel.
Configuration using KPG-111D/ DN
Configuring the Status Message on Data Zone-CH/GID to be enabled or disabled (
FUNC (K)/Ver 4.00
" icon blinks. In this case, a user can read the stored Status Message if the transceiver
3.7 Viewing the Receive History (Stack) on page
FPRG 8.10.6 Common Page 4 Tab)
See
FPRG 8.16.2
See
38.)
See FPRG 8.16.4 Parameter Tab)
CONTENTS INDEX 332