Kenwood NEXEDGE NX-200 Function Reference page 358

12 FleetSync
12.6 Sending and Receiving a Status Message (Status Call)
 Keypad entry
If "Status (FleetSync/NXDN)" is configured for Keypad Operation, pressing a key(s) on the keypad places the
transceiver to enter Status Mode. In this case, a Status Message is addressed to a Target Fleet/ ID.
Also, if "Selcall + Status (FleetSync)" is configured for Keypad Operation, pressing the [0] to [9] keys on the keypad
places the transceiver to enter Selcall Mode. The transceiver enters Status Mode by a user pressing the Menu ([
[*] key after selecting the target transceiver's Selcall ID. (Refer to
The transceiver enters Selcall ID Shortcut Entry Mode or goes into the respective state as the first digit of the Selcall ID
is entered. (Refer to Keypad Operation on page
Operating the Transceiver
 Sending a Status Message by list selection
1
Select one of the following operations to place the transceiver in Status Mode.
• Press the Status (FleetSync/NXDN) key.
The transceiver enters Status Mode. In this case, a Status
Message is addressed to a Target Fleet/ ID.
• Press the Selcall + Status (FleetSync) key.
Pressing the Menu ([
target transceiver's Selcall ID places the transceiver in Status
Mode.
Or, the transceiver enters Status Mode by a user pressing the
Menu key or using a keypad. In this case, the following
operations are identical.
2
Press the Up or Down
to select the target data from Status List.
Refer to Selecting or Clearing Data from a List on page 42
selection methods.
FUNC (K)/Ver 4.00
21.)
]) or [*] key after a user selects the
key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), or press the
Initiating a Selective Call on page
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
]) or
309.)
Mobile
[ ] or [ ] key (Mobile)
Mobile
INDEX 324