Kenwood NEXEDGE NX-200 Function Reference page 226

9 NXDN TRUNKING SYSTEM
9.1 Initiating Voice Communications (Basic Transmission and Reception)
• If the transceiver receives the Priority Monitor ID 2:
• If the transceiver receives the Priority Monitor ID 3:
• If the transceiver receives the Priority Monitor ID 4:
The transceiver can respond to the received Group ID by a user
pressing the PTT switch. When a key other than the PTT switch
is pressed, the configured function will be activated. However,
functions that can be used are limited. When an invalid key is
pressed, the Key Beep B sounds, and then the display will restore
to normal state. Refer to
available functions.
Note
• This function is applicable only if the transceiver is making voice calls using the Group Call. This function is not applicable to data
communications.
• A Group Call can be received only with a Priority Monitor ID while a Group Call is being received using a Group ID, except for the
Group ID configured for Priority Monitor ID. While receiving a Group Call using a Priority Monitor ID, only a Group Call with Priority
Monitor ID having higher priority can be received.
• The transceiver cannot migrate to another traffic channel even if the communication starts on another traffic channel because the
transmitting transceiver on a traffic channel cannot receive.
• The transceiver can receive a Group ID which is configured for Priority Monitor ID even while a scan is temporarily paused.
• During the scan, only the Priority Monitor ID configured for the selected zone is used as a Priority Monitor ID.
FUNC (K)/Ver 4.00
Mode Reset Timer on page 20
•
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for the
Mobile
Mobile
Mobile
CONTENTS INDEX 192