Kenwood NEXEDGE NX-200 Function Reference page 280

9 NXDN TRUNKING SYSTEM
9.20 Sending GPS Data
9.20 Sending GPS Data
Global Positioning System (GPS) is the system to acquire the current location information of the own transceiver by
receiving signals from the Global Positioning System satellites orbiting the earth.
The transceiver of the mobile station can send the acquired own location information (GPS data) to the base station. The
base station can send received GPS data to the PC as serial commands.
A GPS receiver unit compatible with the NMEA-0183 standard is required and it must be connected to the communication
port of the mobile station transceiver to send GPS data.
Transmission Method of GPS Data
Following are the methods to send GPS data. Refer to each section of "Sending GPS Data" in "8 NXDN CONVENTIONAL
SYSTEM" for details.
 Automatic GPS data transmission
 Sending GPS Data Automatically at Certain Intervals (GPS Report Mode)
 Sending GPS Data According to the Request from the Base Station (GPS Report Mode)
 Manual GPS data transmission
 Sending GPS Data Manually by Using a Key (Send the GPS Data)
 GPS data transmission together with voice communications

Sending GPS Data Together With Voice Communications (GPS Combination)
 GPS data transmission together with Status Message
 Sending GPS Data Together With Status Call (GPS Combination)
 GPS data transmission together with Emergency Call
 Sending GPS Data Together With Emergency Call (GPS Combination)
 GPS data transmission during voice communications
 Sending GPS Data during Voice Communications (Data with Voice)
Note
For a transceiver sending the GPS data, "GPS" must be assigned to the communication port connected to the GPS receiver unit.
(Refer to Available Functions for COM Port on page
The ID of the Target Transceiver (Base ID)
Base ID is the ID of the target transceiver used for sending GPS data.
By using KPG-111D/ DN, either Unit ID or Group ID can be configured as Base ID.
The ID of the base station which is responsible for operation and administration of system is normally configured for Base
ID.
GPS data will be sent to the ID configured in the Base ID (GPS) edit box of the NXDN window > GPS tab in KPG-111D/
DN. If Base ID (GPS) is not configured, the GPS data is sent to the ID configured in the Base ID edit box in the NXDN
window > General 1 tab.
Note
In multiple systems, the target ID can be configured for each system.
FUNC (K)/Ver 4.00
524.)
CONTENTS INDEX 246