14 DTMF
14.1 Method of Sending the DTMF Code
3
Select one of the following operations.
• To send the DTMF code and initiate voice calls, the PTT switch
needs to be pressed.
• To send only the DTMF code, the Side 2 key (NX-200/ NX-210/
NX-300/ NX-410/ NX-411) or the Square key (Mobile) needs to
be pressed.
The transceiver sends the DTMF code.
Configuration using KPG-111D/ DN
•
Configuring the Store & Send to be enabled or disabled (
•
Assigning functions to the PF keys on the transceiver (
•
Assigning functions to the Keypad Operation on the transceiver (
Sending the DTMF Code with a Single Touch (Call 1 to Call 6 Keys)
Pressing one of the Call 1 to Call 6 keys can send the DTMF code preconfigured in the transceiver for the key.
Call 1 to Call 6 can be assigned to the PF keys using KPG-111D/ DN and the DTMF code corresponding to each key can
be selected from the Autodial List.
Configuration using KPG-111D/ DN
•
Assigning functions to the PF keys on the transceiver (
•
Configuring the DTMF code corresponding to the Call 1 to Call 6 keys (
Redialing
A previously sent DTMF code can be sent again.
Note
This function is unavailable for NX-200S/ NX-300S.
Operating the Transceiver
1
Press the
Autodial
The transceiver enters Autodial Mode.
2
Press the
[*]
key and then
The DTMF code last sent appears on the main display.
To cancel the operation, the Side 1 (NX-200/ NX-210/ NX-300/
NX-410/ NX-411) or the Triangle key (Mobile) needs to be
pressed.
FUNC (K)/Ver 4.00
key while the transceiver is in standby mode.
[0]
key.
See
FPRG 8.14.1 Encode Tab)
See
FPRG 8.12 Key Assignment Window)
See
FPRG 8.12.2 General Tab)
See
FPRG 8.12 Key Assignment Window)
See
FPRG 8.12.6 Call Tab)
CONTENTS
INDEX
366