Kenwood NEXEDGE NX-200 Function Reference page 244

9 NXDN TRUNKING SYSTEM
9.5 Making an Individual Call (Transmission Trunked)
If the Unit ID is not configured in the Unit ID List, the Unit ID
appears on the main display.
The transceiver can respond to the received Unit ID by a user
pressing the PTT switch. When a key other than the PTT switch
is pressed, the configured function will be activated. However,
functions that can be used are limited. When an invalid key is
pressed, the Key Beep B sounds, and then the display will restore
to normal state. Refer to
available functions.
Note
• If the transceiver receives the Unit ID Name by Over-the-Air Alias, the received Unit ID Name will appear.
• If the Unit ID Name received using Over-the-Air Alias is stored in the stack memory of the transceiver, the stored Unit ID Name will
appear.
• If the received Unit ID is configured in the Unit ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert
Tone (Individual Call) of the corresponding Unit ID. If the received Unit ID is not registered in the Unit ID List, the Alert Tone sounds
from the transceiver according to the configuration for Alert Tone (Individual Call) which is commonly used. In the same manner, the
Alert Tone sounds from the transceiver according to the Alert Tone (Paging Call) configuration corresponding to Unit ID if a Paging Call
is received. If the received Unit ID is not registered in the Unit ID List, the Alert Tone sounds from the transceiver according to the
configuration for Alert Tone (Paging Call) which is commonly used.
• The transceiver can send the ID of the transmitting transceiver from the communication port on the transceiver when receiving an
Individual Call (Transmission Trunked). (Refer to
on page 213.)
Configuration using KPG-111D/ DN
• Configuring the Alert Tone (Individual Call) (Unit ID List) (
• Configuring the Alert Tone (Paging Call) (Unit ID List) (
• Configuring the Alert Tone (Individual Call) which is commonly used (
• Configuring the Alert Tone (Paging Call) which is commonly used (
FUNC (K)/Ver 4.00
Mode Reset Timer on page 20
Sending the Received Unit ID from the Communication Port (Unit ID Serial Output)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for the
See FPRG 8.19.6 Unit ID List Tab)
See FPRG 8.19.6 Unit ID List Tab)
FPRG 8.19.4 Trunking Tab)
See
FPRG 8.19.4 Trunking Tab)
See
Mobile
CONTENTS INDEX 210