Omron V460-H User Manual page 66

• Duplicate Code Timeout – The reader will only read the same code after a certain timeout has
passed. (Note that this is only shown when in Continuous Read 1 Output, which can be changed in
Advanced > Read Cycle > Trigger > Mode) (20 msec to 655350 msec).
• Timeout After – This is the amount of time the reader is allowed to spend for the entire read cycle,
acquiring and processing images until all codes are read. Set this value long enough to be able to
decode in all circumstances, but short enough to prevent the camera from taking longer than the
allowed cycle time of the production line. (20 msec to 655350 msec). (Note that this is only shown
when in Continuous Read, which can be changed in Advanced > Read Cycle > Trigger > Mode).
Note: When the reader is in Presentation mode and Time of Flight is set to Enabled in (its default
setting) in Camera Setup, there is no Timeout. The reader will begin to acquire and process images
as soon as an object is placed in front of the reader, and it will continue to do so until the object is
removed. Once a symbol is found in the field of view, the reader will report the symbol a single time.
Acquisition and image processing will continue for as long as the object is positioned in front of the
reader. When the object is removed, acquisition and image processing will stop. The symbol that was
decoded will not be reported again until the object is removed and placed in front of the reader a sec-
ond time, or until a different symbol is read during the same cycle. Time of Flight can be changed in
Advanced Settings > Camera Setup.
V460-H Industrial Handheld DPM Reader User Manual
3 Basic Operation
3-25
3