Omron V460-H User Manual page 229

4 WebLink Configuration
HH
Symbologies
The Symbologies menu shows all the commands that allow you precise control of the parameters of all
enabled code types. Parameters differ depending on the unique standards of each code type.
Command parameters can be changed directly from this menu.
Symbologies Menu
Important: Detailed explanations of the following commands and parameters are located in the
Symbologies section of the V460-H Handheld Code Reader User Manual.
DotCode
DotCode is a special code type that can be enabled using the standard Code Type dialog box or using
Advanced Settings.
Important: When DotCode is enabled, no other symbologies will be decodable. You must disable
DotCode to decode symbols of any other type.
DotCode parameters can be found in the Symbologies menu located in WebLink's Advanced Settings.
By default, DotCode will look for either horizontal or vertical codes with no rotation (plus or minus 3
degrees). The user can set Rotation Mode to Low Rotation (plus or minus 10 degrees) or to Omni
Directional.
When using DotCode, the user can specify the exact number of rows and columns in the code to
minimize the possibility of decoding errors and no reads. If you specify the exact row and column
dimensions, only DotCode symbols of the same dimension are decoded.
To do this, you must enter the row and column values using a K command via the Terminal under
Settings, or via another serial link.
Important: DotCode must be enabled for the column and row settings to take effect.
4-146
V460-H Industrial Handheld DPM Reader User Manual