Omron V460-H User Manual page 406

DotCode
Important: When DotCode is enabled, no other symbologies will be decodable. You must disable
DotCode to decode symbols of any other type.
See DotCode in
DotCode symbols.
7-1-72 DotCode Status
Serial Cmd:
Default:
Options:
Disabled
The reader will not attempt to decode DotCode symbols.
Enabled
The reader will attempt to decode DotCode symbols.
7-1-73 Rotation Mode
Serial Cmd:
Default:
Options:
No Rotation
The reader will decode horizontal and vertical symbols (+/– approximately 3 degrees).
Low Rotation
The reader will decode +/– approximately 10 degrees from the horizontal or vertical symbols. It is
slightly slower than the No Rotation option.
Omnidirectional
The reader supports 360 degree decoding. It is significantly slower than the other two options.
V460-H Industrial Handheld DPM Reader User Manual
Advanced Settings for details about how to specify row and column dimensions of
<K497,status,rotation mode>
0 = Disabled
0 = Disabled
1 = Enabled
<K497,status,rotation mode>
0 = No Rotation
0 = No Rotation
1 = Low Rotation
2 = Omnidirectional
7 Symbology Parameters
7
7-31