Utilities - Omron V460-H User Manual

5-7

Utilities

5-7-1 Utility Commands
Type
Counter Request/Clear
Firmware Verification
Read Rate
Read Cycle
Enable/Disable
Parameter Reset/Save
Resets
Save for Power-On
Master Database
Reader Status
Train/Optimize
Barcode Configuration
V460-H Industrial Handheld DPM Reader User Manual
Command
<q> No-Reads Per Read Cycle Counter
<q0> No-Reads Per Read Cycle Counter Reset
<$> Mismatch Per Read Cycle Counter
<$0> Mismatch Per Read Cycle Counter Reset
<N> No-Read Counter
<O> No-Read Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
<V> Match Code Counter
<W> Match Code Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
<#> Request All Part Numbers
<#a> Request Application Firmware Part Number
<#b> Request Boot Code Firmware Part Number
<!> Request All Firmware Checksums
<!a> Request Application Firmware Checksum
<!b> Request Boot Code Firmware Checksum
<!s> Request Current Parameter Settings Checksum
<C> Decodes Per Second Test
<Cp> Decode Percent Test
<J> Exit Read Rate Tests
<a1> Preface PDF417 Output with Data Attributes
<I> End Current Read Cycle until <H>
<H> Enable Read Cycle after <I>
Complete Reset when Resets or Save for Power-On
<A?/1>
Command Has Been Issued
<A?/0> Warm Reset if Power-On Command Has Been Issued
<A> Software Reset, Current Parameters Retained
Software Reset, Recall Default Parameters except Commu-
<Ard>
nication and Custom Unit Name Parameters
<Arp> Software Reset, Recall Power-On Default Parameters
<Arc> Software Reset, Recall Customer Default Parameters
<Z> Software Reset, Save Current Settings for Power-On
Software Reset, Save Current Settings as Customer
<Zc>
Default Parameters
Software Reset, Recall Customer Default Parameters
<Zrc>
and Save for Power-On
Software Reset, Recall Microscan Default Parameters
<Zrd> Except Communication and Custom Unit Name Parameters
and Save for Power-On
Software Reset, Recall Microscan Default Parameters
<Zrdall> Including Communication and Custom Unit Name
Parameters and Save for Power-On
<G> Store Next Symbol Read to Database Index 1
<Gn> Store Next Symbol Read to Database Index n
<NEWM> New Master Load Status
<?> Reader Status Request
<TRAIN> Initiate Train Operation
<UNTRAIN> Initiate Untrain Operation
<TRAIN?> Train Status Request
<OPT> Initiate Optimize Operation
<UNOPT> Initiate Un-Optimize Operation
<OPT?> Display Optimize Status
<BCCFG> Enter Barcode Configuration
5 Reader Parameters
Name
5
5-63