Omron V460-H User Manual page 419

9 Service and Maintenance
Cleaning the Reader
Routinely cleaning the exit window is required. A dirty window may affect scanning accuracy. Do not
allow any abrasive material to touch the window.
To clean the reader:
1
Dampen a soft cloth with one of the approved cleaning agents listed above or use pre-moistened
wipes.
2
Gently wipe all surfaces, including the front, back, sides, top and bottom. Never apply liquid
directly to the reader. Be careful not to let liquid pool around the reader window, trigger, cable
connector or any other area on the device.
3
Be sure to clean the trigger and in between the trigger and the housing (use a cotton-tipped applicator
to reach tight or inaccessible areas).
4
Do not spray water or other cleaning liquids directly into the exit window.
5
Wipe the reader exit window with a lens tissue or other material suitable for cleaning optical
material such as eyeglasses.
6
Immediately dry the reader window after cleaning with a soft non-abrasive cloth to prevent
streaking.
7
Allow the reader to air dry before use.
8
Reader connectors:
(1) Dip the cotton portion of a cotton-tipped applicator in isopropyl alcohol.
(2) Rub the cotton portion of the cotton-tipped applicator back-and-forth across the connector
on the reader at least 3 times. Do not leave any cotton residue on the connector.
(3) Use the cotton-tipped applicator dipped in alcohol to remove any grease and dirt near the
connector area.
(4) Use a dry cotton tipped applicator and rub the cotton portion of the cotton-tipped applicator
back-and-forth across the connectors at least 3 times. Do not leave any cotton residue on
the connectors.
9-4
V460-H Industrial Handheld DPM Reader User Manual