Omron V460-H User Manual page 176

No Read: Will beep when the read cycle ends without reading all codes.
•
Boot and Program: Will beep when the reader's firmware or WebLink
•
when the reader decodes a programming barcode, and when the reader is booting up.
All: Will beep when any of the above events are met.
•
Volume
Sets the beeper's volume.
Note: You can also set the volume by clicking the
Medium, Low, and Disabled. Each click increments the volume setting by one. When the Beeper setting
is High, you can click the Beeper icon once more to disable the Beeper. Clicking the Beeper icon one
additional time will return Beeper volume to Low, and will return the Beeper to the original Beeper
Feedback condition. For example, if Beeper Feedback is set to Boot and Program and then the Beeper
is disabled, Beeper settings will return to Boot and Program and Low volume when the icon is clicked
once more.
V460-H Industrial Handheld DPM Reader User Manual
4 WebLink
has been updated,
HH
icon multiple times to cycle through High,
Configuration
HH
4-93