Omron V460-H User Manual page 181

4 WebLink Configuration
HH
New Read Cycle: Saves a cycle of data until the next read cycle (default).
•
System Reset: Saves data until the system is reset – when maximum storage capacity is
•
reached, the Action at Image Storage Limit parameter determines whether or not data is
overwritten.
The Action at Image Storage Limit setting allows the user to decide what action is taken once the
storage limit is reached. Options are:
Stop: Stop saving images and cycle reports when maximum storage reached (default).
•
• Erase Oldest: Overwrite oldest image and cycle report when maximum storage reached.
If Image Storage Location is set to Remote FTP, the FTP Address will appear, allowing you to input the
user ID, password, and address of the applicable FTP server.
The FTP Address represents the FTP host settings on the device to where images and reports are
saved. This device must be running an FTP server.
userid: User ID configured on the FTP host server.
•
• pass: Password associated with the user ID of the FTP host server.
• xxx.xxx.xxx.xxx: IP address of the FTP host device.
port: Which host port to use – default is 21.
•
The Transfer Optimization parameter configures how images and reports are sent to the FTP host.
Options are:
Speed: Images and reports are sent via a lossy mechanism – this method focuses on
•
maintaining trigger integrity, which could possibly result in some images or reports being dropped
(default).
Accuracy: Images and reports are sent via a lossless mechanism – this method transmits all
•
images and reports which could possibly result in triggers being delayed or read cycles being
prematurely terminated.
The Transfer Buffer Size parameter defines the maximum buffer size used per cycle. If the Transfer
Buffer Size parameter changes, the message shown below will appear in the Image Storage Location
dialog. If you click Revert, the RAM drive size returns to its previous size. The default size is 20 MB.
4-98
V460-H Industrial Handheld DPM Reader User Manual