Omron V460-H User Manual page 197

4 WebLink Configuration
HH
Activate Account Management
Activate Account Management allows you to set a password that will be required to open any session
of WebLink . An Administrator can create, update, and delete users from an Administrator user
HH
interface. While management is active, every user must log in with a username and password
established by the Administrator to use WebLink
different privilege level that determines their access:
Administrator (Full Access as well as the ability to manage user accounts and enable or disable
•
Account Management)
• Controller (Full Access)
Monitor (View-Only Access)
•
Click the gear icon at the upper right of the WebLink
Settings menu.
Then click Activate Account Management to open the dialog shown below.
Enter and verify a new username and password and then click Activate Account Management to
password-protect the WebLink
characters.
The Activate Account Management button brings up a dialog allowing you to create an Administrator
account and to Activate Account Management. This is the same account information that you will use to
log in to the application later, so be sure to remember it. After entering valid credentials, click the blue
4-114
. There are three different user types, each with a
HH
user interface to open the Application
HH
configuration. The password must be at least 5 ASCII-readable
HH
V460-H Industrial Handheld DPM Reader User Manual