Installing An Mx240 Dpc - Juniper MX240 Hardware Manual

Figure 106: Removing a DPC
SEE ALSO
MX240 Dense Port Concentrator (DPC) Description | 113
MX240 Dense Port Concentrator (DPC) LEDs | 119
Troubleshooting the MX240 DPCs | 429

Installing an MX240 DPC

A DPC weighs up to 14.5 lb (6.6 kg). Be prepared to accept its full weight.
To install a DPC (see Figure 107 on page
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Place the DPC on an antistatic mat, or remove it from its electrostatic bag.
3. Identify the slot on the router where it will be installed.
4. Verify that each fiber-optic transceiver is covered with a rubber safety cap. If it does not, cover the
transceiver with a safety cap.
5. Orient the DPC so that the faceplate faces you.
6. Lift the DPC into place, and carefully align the sides of the DPC with the guides inside the card cage.
7. Slide the DPC all the way into the card cage until you feel resistance.
324):
322