Installing Components; Installing The Mx240 Craft Interface; Chapter 21 Installing Components - Juniper mx240 Hardware Manual

CHAPTER 21

Installing Components

Installing the MX240 Craft Interface

Copyright © 2016, Juniper Networks, Inc.
Installing the MX240 Craft Interface on page 223
Installing the MX240 Air Filter on page 224
Installing the MX240 Normal-Capacity Fan Tray on page 225
Installing an MX240 Routing Engine on page 226
Installing an MX240 DPC on page 227
Installing an MX240 FPC on page 230
Installing an MX240 MIC on page 233
Installing an MX240 MPC on page 235
Installing an MX240 Dual-Wide MIC on page 237
Installing an MX240 PIC on page 239
Installing an MX240 AS MLC on page 241
Installing an MX240 AS MSC on page 242
Installing an MX240 AS MXC on page 243
Installing a Cable on an MX240 DPC, MPC, MIC, or PIC on page 245
Installing an SFP or XFP Transceiver into an MX240 DPC, MPC, MIC, or PIC on page 246
Installing an MX240 AC Normal-Capacity Power Supply on page 247
Installing an MX240 DC Normal Capacity Power Supply on page 248
Installing an MX240 SCB on page 251
To install the craft interface (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
2.
with the other hand to support its weight.
Orient the ribbon cable so that it plugs into the connector socket. The connector is
3.
keyed and can be inserted only one way.
Figure 87 on page 224):
223