Installing And Closing The Compute Node Cover - IBM Flex System p270 Compute Node Installation And Service Manual

2. Install the compute node into the IBM Flex System Enterprise Chassis. See "Installing the compute
node in an IBM Flex System Enterprise Chassis" on page 92.
3. Turn on the compute node, as described in "Turning on the compute node" on page 10.
Note: If you have just connected the power cords of the IBM Flex System Enterprise Chassis to
electrical outlets, you must wait until the power-on LED on the compute node flashes slowly before
you press the power-control button.
4. If you installed an I/O expansion card, use the documentation that comes with the expansion card to
install device drivers and to perform any configuration that the expansion card requires.
5. For certain optional devices, run the compute node SMS Utility program, as described in "Using the
SMS utility" on page 18.

Installing and closing the compute node cover

Install and close the cover of the compute node before you insert the compute node into the IBM Flex
System Enterprise Chassis. Do not attempt to override this important protection.
About this task
Figure 50. Installing the cover for an IBM Flex System p270 Compute Node
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always replace
the compute node cover before you install the compute node.
Chapter 6. Installing and removing components
91