Installing And Closing The Blade Server Cover - IBM power PS700 Problem Determination And Service Manual

Installing and closing the blade server cover

Install and close the cover of the blade server before you insert the blade server into the BladeCenter
unit. Do not attempt to override this important protection.
Figure 11. Installing the cover
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always replace
the blade server cover before installing the blade server.
Perform the following procedure to replace and close the blade server cover.
1. Read the Safety topic and the "Installation guidelines" on page 233.
2. Lower the cover so that the slots at the rear slide down onto the pins ( 1 in Figure 11) at the rear of
the blade server. Before you close the cover, verify that all components are installed and seated
correctly and that you have not left loose tools or parts inside the blade server.
Chapter 4. Removing and replacing blade server components
239