IBM Flex System p270 Compute Node Installation And Service Manual page 99

Figure 49. Installing the bezel assembly in an IBM Flex System p270 Compute Node
18. Install and close the compute node cover. See "Installing and closing the compute node cover" on
page 34.
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always
replace the compute node cover before you install the compute node.
19. Write the machine type, model number, and serial number of the compute node on the repair
identification tag that is provided with the replacement system-board and chassis assembly. This
information is on the identification label that is on the lower right corner of the bezel on the front of
the compute node.
Important: Completing the information about the repair identification tag ensures future entitlement
for service.
20. Place the repair identification tag on the bottom of the compute node chassis.
21. Install the compute node into the IBM Flex System Enterprise Chassis. Do not turn on the compute
node until step 26 on page 89 or 27 on page 89 of this procedure, depending upon whether the
compute node is managed by a management console. For more information about how to install the
compute node, see "Installing the compute node in an IBM Flex System Enterprise Chassis" on page
92.
Chapter 6. Installing and removing components
87