IBM Flex System p270 Compute Node Installation And Service Manual page 374

26D7-135 • 26D7-138
26D7-135
Explanation: The device failed to configure. Replace each part reported by the diagnostic program one at a time.
Retry the diagnostic test after each part is replaced. If the problem persists, replace the next part in the list.
Response:
Failing Item:
v FFC_26D7
v FFC_B88
v SOFTWARE
26D7-136
Explanation: The certify operation failed. Replace the 900 GB SFF SAS Hard Disk Drive.
Response:
Failing Item:
v FFC_26D7
26D7-137
Explanation: Unit attention condition has occurred on the Send Diagnostic command. Replace the 900 GB SFF SAS
Hard Disk Drive. Run diagnostics again on the drive. If the error repeats, replace the 2nd FRU identified by
diagnostics.
Response:
Failing Item:
v FFC_26D7
v FFC_B88
26D7-138
Explanation: Error log analysis indicates that the disk drive is operating at a higher than recommended
temperature.
1. Make sure that:
v The ventilation holes in the blade server bezel are not blocked.
v The Management Module event log is not reporting any system environmental warnings.
2. If the problem remains, call IBM support.
Response:
Failing Item:
v FFC_26D7
362
Power Systems: IBM Flex System p270 Compute Node Installation and Service Guide