Table of Contents
Advertisement
ctrlX SAFETY "SafeMotion"
76 / 302
Safety functions in special mode "Safe standstill"
Features
The safety function "Safe operating stop (SOS)" has the following features:
● The safety function can be used in drive systems equipped with the optional
● The safety function is intended for safety-relevant applications up to
● The safety function can only be used if it has been configured during com-
● The energy supply to the motor is not interrupted.
● The controlled operation at standstill is monitored using a monitoring
Monitoring the actual position
● If the monitoring window for the safe operating stop is left, an error reaction
● If the velocity threshold for safe standstill (P‑0‑3255) is fallen below
Fig. 23: Safety function "Safe operating stop" with monitoring of the actual
position
Command value monitoring
● With the safety function activated, the standard firmware monitors, in addi-
Bosch Rexroth AG
safety technology module "Mx".
Category 3, PL d according to EN ISO 13849-1 or SIL 2 according to
EN 62061.
missioning (P‑0‑3285.0.1).
window for the safe operating stop (P‑0‑3285.0.2).
is triggered (F7030), setting the drive to standstill.
during the transition to safe state, the standstill monitoring becomes active
(P‑0‑3285.0.2) and the axis has to come to a standstill. Thus, ensure that the
velocity threshold for safe standstill (P‑0‑3255) is sufficiently small.
tion to the monitoring functions of the safety technology, that there are
no velocity command values greater than the standstill window (S‑0‑0124),
preset for the drive (P‑0‑0048). If larger velocity command values are speci-
fied, an error reaction is triggered (F6200), setting the drive system to
standstill.
R911404905, Edition 02
Advertisement
Table of Contents
