Table of Contents
Advertisement
ctrlX SAFETY "SafeMotion"
18 / 302
Instructions with regard to specific dangers
4.2.5
Protection against contact with hot parts
● Do not touch hot surfaces of, for example, braking resistors, heat sinks,
● According to the operating conditions, temperatures of the surfaces can be
● After having switched them off, allow the motors to cool down long enough
● After switching off chokes, supply units and drive controllers, wait 15
● Wear safety gloves or do not work at hot surfaces.
● For certain applications, and in accordance with the respective safety regu-
4.2.6
Protection during handling and mounting
Risk of injury by improper handling! Personal injury by crushing, shearing, cut-
ting, hitting!
● Comply with the relevant statutory regulations of accident prevention.
● Use suitable mounting and transport equipment.
● Avoid jamming and crushing by appropriate measures.
● Always use suitable tools. Use special tools if specified.
● Use lifting equipment and tools in the correct manner.
● Use suitable protective equipment (hard hat, safety goggles, safety shoes,
● Do not stand under hanging loads.
● Immediately clean up any spilled liquids from the floor due to the risk of
4.2.7
Battery safety
Batteries consist of active chemicals in a solid housing. Therefore, improper
handling can cause injury or property damage. Risk of injury by improper han-
dling!
● Do not attempt to reactivate low batteries by heating or other methods (risk
● Do not attempt to recharge the batteries since this may cause leakage or
● Do not throw batteries into open flames.
● Do not disassemble any batteries.
● When replacing the battery/batteries, do not damage the electrical parts
● Only use the battery types specified for the product.
Environmental protection and disposal! The batteries contained in the product
are considered dangerous goods during land, air, and sea transport (risk of
explosion) in the sense of the legal regulations. Dispose of used batteries sepa-
rately from other waste. Comply with the national regulations of your country.
Bosch Rexroth AG
supply units and drive controllers, motors, windings and laminated cores!
higher than 60 °C (140 °F) during or after operation.
before touching them. Cooling down may require up to 140 minutes. The
time required for cooling down is approximately five times the thermal time
constant specified in the technical data.
minutes to allow them to cool down before touching them.
lations, the manufacturer of the machine or system must take measures to
avoid injuries caused by burns in the final application. Possible measures:
warnings at the machine or system, guards (shieldings or barriers) or safety
instructions in the application documentation.
safety gloves, for example).
falling!
of explosion and cauterization).
explosion.
installed in the devices.
R911404905, Edition 02
Advertisement
Table of Contents
