ctrlX SAFETY "SafeMotion"
241 / 302
Machine acceptance test
10.5.9
Signal control of outputs
The
"Signal
control
of
outputs"
dialog
can
be
opened
in
"... Machine acceptance test
Signal
ctrlX DRIVE Engineering via the
control of outputs" node.
The dialog is not provided if no source signal has been assigned to the safe
output in "P‑0‑3335.0.2, SMO: Signal control of outputs discrete, bit number".
In this dialog, it is possible to check whether the signal applied to the safe local
output is correctly processed.
Fig. 116: Machine acceptance test: Signal control of outputs
Parameters involved:
● P‑0‑3335.0.1, SMO: Signal control of outputs discrete, IDN assignment
● P‑0‑3335.0.2, SMO: Signal control of outputs discrete, bit number
R911404905, Edition 02
Bosch Rexroth AG