Table of Contents
Advertisement
ctrlX SAFETY "SafeMotion"
178 / 302
First use
Fig. 71: Parameter verification
After the axis identifier was verified, the identification of the axis can be car-
ried out. After the "Identify SafeMotion" button was clicked, the diagnostic
LEDs PF40 and PF41 at the "SafeMotion" option are flashing at the connected
drive for which the axis identifier is set, with the flashing pattern "red - green -
green - red". In addition, the display of the control panel shows the Confirm
SMO axis identifier:... message.
Fig. 72: Dialog for applying the axis identifier
The axis identifier has to be confirmed by pressing the
panel or by clicking the "Apply axis identifier" button in the dialog provided for
applying the axis identifier.
By pressing the
assignment of the axis identifier can be aborted.
For devices without panel, the axis identifier can only be confirmed using the
"Apply axis identifier" button in the corresponding dialog.
Bosch Rexroth AG
[ESC]
key at the panel or by clicking the "Cancel" button, the
[Enter]
key at the
R911404905, Edition 02
Advertisement
Table of Contents
