Msl-100 System Administration - Nortel Meridian SL-100 Reference Manual

2-16 Installation procedures
4
5
6
7
8

MSL-100 system administration

MSL-100 has added the ATA line class code in MSL08 for system
configuration in SERVORD. The ATA is datafilled on the odd LEN of the
IPE/DLM port along with a Meridian 2006, 2008, 2008HF, 2616 or 2216
datafilled on the even LEN.
Table
Example of adding the ATA line class code for system configuration in
SERVORD
Prompt
SO
LCC
555-4001-114 Standard 10.02 November 1999
Install the footstand into the telephone base by inserting the two footstand tabs
into the notches on the base of the telephone.
Screw the footstand into position using the two screws provided and a Phillips
screwdriver.
Plug the output of the external power module into the circular mini DIN
connector located on the back wall of the footstand. Plug the input of the
external power module into the commercial 110V electrical outlet.
WARNING
Use only the Class 2 power source included with your
ATA. Specifications:
The transformer that accompanied the earlier MCA,
MPDA or external alerter interface board (NT A0367335)
is not compatible with the ATA.
Place the power sticker on the back of the footstand. Place the bar code sticker
on the base of the set.
You are now ready to connect the analog device to the RJ11 connector located
on the back wall of the footstand. Refer to the installation documentation
packaged with your analog device.
2-3xxx
NT A0688664
Input rated: 120V ac, 50-60Hz, 23 watts
Output rated: 24V ac, 600 mA, and 8V ac, 400
mA
Response
NEW
ATA
Description
Establish service for
unassigned telephone lines.
ATA line class code