To Connect The Ata2; To Mount The Ata2 On A Wall; Mounting The Ata2 - Nortel N0060609 Installation Manual

Bcm 4.0 telephony device
Table of Contents

Advertisement

Figure 6 ATA2 pin-outs
Line jack
* The TCM input is not polarity sensitive.

To connect the ATA2

1
Connect one end of a line cord to the ATA2 terminal jack.
2
Connect the other end to your telephone, modem, or fax machine.
3
Connect one end of a line cord to the ATA2 line jack.
4
Connect the other end to an available station port on the BCM main unit or expansion unit.
5
For a 120 V or 230 V system, plug the DIN connector of the power supply cord into the power
supply connector receptacle. Plug the adapter into a standard AC outlet.
Caution: In North America, the ATA2 must be powered from a Class 2 power source that
is UL- and CSA-approved.
In Europe, the ATA2 must be powered from a Class II power source that is CE marked.

Mounting the ATA2

After the ATA2 is correctly connected, you can mount the unit on a wall, as described in this
section.

To mount the ATA2 on a wall

1
When using 0.5 mm wire (24 AWG), select a location within 800 m (2600 ft.) of the BCM
main unit.
2
Allow 12.5 cm (5 in.) clearance for the line jack, terminal jack, and power supply connector.
3
Screw two 4-mm (#8) screws into the wall, 130 mm (5 1/4 in.) away from each other. Leave
6 mm (1/4 in.) of the two screws showing.
4
Align the slots at the back of the ATA2 unit over the screws. Push the unit against the wall.
The line jack, terminal jack, and power supply connector must be at the top of the ATA2 (see
Figure
7).
Chapter 4 Installing the analog terminal adapter
TCM*
TCM*
BCM 4.0 Telephony Device Installation Guide
Terminal jack
Ring (B-Lead)
Tip (A-Lead)
25

Advertisement

Table of Contents
loading

Table of Contents