Table of Contents
Advertisement
5
Install the power supply using a method appropriate for your installation. For details about
installation options, see
To install a BCM50 unit on top of another unit
Warning: For safety reasons, do not stack more than one unit on top of a first
BCM50 unit.
1
Insert the power-supply retention clip into the BCM50 unit.
2
Place the BCM50 unit on top of the first unit. Make sure the feet of the second unit are in front
of the slots on the top of the first unit.
3
Slide the unit back until it clicks in place on the slots.
4
Install the power supply using a method appropriate for your installation. For details about
installation options, see
To install the patch panel (optional)
1
Determine the location in the rack where you want to install the patch panel.
2
Position the patch panel in the rack.
3
Align the holes in the patch panel with the holes in the equipment rack rails.
4
Fasten the patch panel to the rack using the four rack screws (supplied with the patch panel).
Wall-mount installation
To install a BCM50 unit (main unit or expansion unit) on a wall, you need a wall-mount bracket
for each unit. Each wall-mount bracket includes a cable-management tray to store and organize the
cables connected to the BCM50 units. An optional wiring-field card simplifies the cable
connections for the lines and extensions.
Caution: BCM50 units must be installed side-by-side on a wall. DO NOT attempt to
install units on top of each other when using the wall-mount option.
Use the following procedures to install a BCM50 unit on a wall:
•
To install the BCM50 wall-mount bracket
•
To install a BCM50 unit on the wall-mount bracket
Installing the BCM50 power supply
Installing the BCM50 power supply
on page 20
Chapter 3 Hardware installation
on page 22.
on page 22.
on page 21
Installation Checklist and Quick Start Guide
19
2 minutes
2 minutes
Advertisement
Table of Contents
