Konica Minolta bizhub PRO 1050 Service Manual page 89

Field Service Ver3.0 Nov.2006
E. Replacing the developer
[2]
[1]
(1) Periodically replaced parts/cycle
• Developer: 1,000,000 prints or 220 hours drive, whichever is earlier
(2) Procedure
[4]
[3]
[1]
NOTE
• When replacing the developer, be careful that
dirt does not get into it.
• When rotating the developing roller [1], be
sure to rotate the developing gear to the
arrow-marked direction [2] with the flat blade
driver.
• When putting in new developer, be sure to
reset the developer counter in the service
mode. If not reset, image fogging and toner
splash may result.
1050fs2112c
1.
Pull the photo conductor section out of the main
body.
[2]
(See P.38)
2.
Remove the developing suction assembly.
(See P.53)
3.
Remove the developing unit.
(See P.55)
4. Release 2 hooks [1] and remove the developing
1050fs2113c
unit cover /1 [2].
5.
Release 2 hooks [3] and remove the developing
unit cover /2 [4].
3. PERIODIC CHECK
(See P.350)
57
1