Konica Minolta bizhub PRO 1050 Service Manual page 211

Field Service Ver3.0 Nov.2006
[1]
[4]
[3] [2]
[5]
1050fs2186c
[1]
[2]
1050fs2409c
7. Cut off the wiring band [1].
NOTE
• When attaching a new wiring band, be sure to
use a heat-resistant one.
8. Remove the screw [2] and then remove the ther-
mistor /2 assembly [3].
NOTE
• When reinstalling the thermistor /2 assembly,
check surely to see if it is in touch with the
fusing roller /Up [4].
9. Remove the connector [5] of the thermistor /2.
NOTE
• There are 4 connectors for the thermistor pro-
vided at the same place and it is difficult to
identify a corresponding
advance. Therefore, the connector to be
removed can be identified by following the
wiring harness of the thermistor /2.
10.
Remove the screw [1] and then remove the ther-
mistor /2 [2].
11. Reinstall the above parts following the removal
steps in reverse.
3. PERIODIC CHECK
connector in
179