Konica Minolta bizhub PRO 1050 Service Manual page 574

Field Service Ver3.0 Nov.2006
Classifi- Jam
cation code
Fusing/ J32-02
paper
exit
J32-03
J32-04
J32-05
J32-06
J32-07
J32-08
J32-09
J32-10
J32-11
J32-12
J32-13
External J51-01
Cause
The ADU acceleration sensor (PS49)
does not turn ON within a specified
period of time after the fusing exit sen-
sor (PS22) turns ON.
The reverse sensor /1 (PS48) does not
turn ON within a specified period of
time after the ADU acceleration sensor
(PS49) turns ON.
The PS46 does not turn ON again
within a specified period of time after
the reverse sensor /1 (PS48) turns ON.
The paper exit sensor (PS3) does not
turn ON within a specified period of
time after the reverse sensor /1 (PS48)
turns ON.
The paper exit sensor (PS3) does not
turn OFF within a specified period of
time after the PS3 turns ON.
The paper exit sensor (PS3) turns ON
while in idling.
The ADU acceleration sensor (PS49)
turns ON while in idling.
The fusing exit sensor (PS22) turns ON
while in idling.
The reverse/exit sensor (PS50) turns
ON while in idling.
The fusing jam sensor (PS23) turns ON
while in idling.
The reverse sensor /1 (PS48) turns ON
while in idling.
The reverse sensor /2 (PS47) turns ON
while in idling.
The front door/R, /L of the main body
was opened while printing.
Resulting
operation
If there is a sheet Open the main body
of paper being front doors /R and /L,
printed when a pull out the ADU section
jam occurs, the and remove jammed
main body com- paper if any.
pletes the paper
exit before stop-
ping operations.
—
The main body Open the main body
stops immedi- front doors /R and /L,
ately. pull out the ADU section
and remove jammed
paper if any.
13. JAM CODE
Correction
539
2