Konica Minolta bizhub PRO 1050 Service Manual page 409

Field Service Ver3.0 Nov.2006
NO CSRC
parameter
(Z1)
111 6E FS Staple/Front
112 6F FS Staple/Back
113 70 FS solenoid /A
114 71 FD feed roller /A Top
115 72 FD reverse rubber /Top
116 73 FD feed roller /B Top
117 74 FD feed roller /A Low
118 75 FD reverse rubber /Low
119 76 FD feed roller /B Low
120 77 FD punch motor assy
121 78 FD solenoid /A (release 1)
122 79 FD solenoid /A (release 2)
123 7A FD motor assy
124 7B LS1 solenoid (Lead)
125 7C LS1 solenoid (Rear)
126 7D LS1 solenoid (Center)
127 7E LS1 solenoid (Curl)
128 7F LS1 Up/Down motor
129 80 LS2 solenoid (Lead)
130 81 LS2 solenoid (Rear)
131 82 LS2 solenoid (Center)
132 83 LS2 solenoid (Curl)
133 84 LS2 Up/Down motor
134 85 SD Staple/Right
135 86 SD Staple/Left
136 87 SD trimmer edge
137 88 SD trimmer receiver
Parts name Parts No.
15AA4222
15AA4222
56QA8251
50BA-574
13QN-443
50BA-575
50BA-574
13QN-443
50BA-575
15AG-573
56QA8251
56QA8251
129U-108
15AV8252
15AV8253
15AV8251
15AV8255
15AV8003
15AV8252
15AV8253
15AV8251
15AV8255
15AV8003
15AN-550
15AN-550
15AN-570
15AN5282
Count conditions
1 count for each paper exit in either of the 1-
staple at front or the 2-staple mode.
1 count for each paper exit in either of the 1-
staple at rear or the 2-staple mode.
1 count for each paper exit in the non-sort
mode and the sort mode.
Counts the paper feed from PI tray /Up.
Counts the paper feed from PI tray /Lw.
1 count for each paper exit in the punch mode.
1 count for each paper exit in the punch or fold-
ing mode (all size).
• 1 count for each paper exit in the folding
mode (all size)
• 1 count for each paper exit in the punch
mode (paper length 220 mm or larger).
1 count for each paper exit to the main tray.
1 count for each paper exit in the non-sort and
sort mode (all size).
1 count for each paper exit in the non-sort and
sort mode (Length 295 mm or more and Width
226 or more).
1 count for each paper exit in the non-sort
mode.
Counts operation number of times of the
stacker tray up down motor.
1 count for each paper exit in the non-sort and
sort mode (all size).
1 count for each paper exit in the non-sort and
sort mode (Length 295 mm or more and Width
226 or more).
1 count for each paper exit in the non-sort
mode.
Counts operation number of times of the
stacker tray up down motor.
1 count for each paper exit in the saddle stitch
mode.
1 count for each paper exit in the trimming
mode.
10. SERVICE MODE
377
1