Konica Minolta bizhub PRO 1050 Service Manual page 381

Field Service Ver3.0 Nov.2006
10.4.3 Drum peculiarity manual
Do not conduct this adjustment in the field.
10.4.4 User paper setting
Use this adjustment when the transfer and separation
functions do not work satisfactorily with the standard
adjustments because of using special papers, etc.
This setting is applied when you select [User] as the
paper type.
By default, the following data are inputted.
• For Japan: 62 to 71 g/m
• For inch area: 72 to 91 g/m
• For metric area: 72 to 91 g/m
NOTE
• Input data according to instructions of KMBT
field support section.
A. Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [02 Process Adjustment] key.
3. A sub menu appears on the right side of the
screen.
Press the [04 User Paper Setting] key on the
sub menu.
4. "User Paper Setting screen"
Select one of the followings; [User Paper 1] /
[User Paper 2] / [User Paper 3]
Press the [Next] and [Back] key to select an
item you adjust.
5.
Input data for the selected item, and press the
[Set] key.
6.
Repeat steps 4 and 5 to configure other items.
2
Normal paper
2
Normal paper
2
Normal paper
10.4.5 Recall standard data
Reset the adjustment values of the process adjust-
ment to the factory initial data or the installation initial
data.
A. Procedure
1. Enter the service mode.
2. "Service mode menu screen"
Press the [02 Process Adjustment] key.
3.
A sub menu appears on the right side of the
screen.
Press the [05 Recall Standard Data] key on the
sub menu.
4.
"Recall standard data (Process adjustment)
screen"
Press the [Factory initial data] or the [Installation
initial data] key.
Note
• Selecting [Factory initial data] recalls the
factory initial data.
• Selecting [Installation initial data] recalls
the adjustment values stored when code
"91-00" of the I/O check mode was con-
ducted.
• When selecting [Data at shipment] or [Data
at installation], the data returns with no dis-
play changed on the screen.
User Paper Setting (Areas)
Bereich <Anfang bis A>: lead edge
Bereich <A bis B>: center 1
Bereich <B bis C>: center 2
Bereich <C bis D>: rear edge 1
Bereich <D bis Ende>: rear edge 2
10. SERVICE MODE
349
2