Konica Minolta bizhub PRO 1050 Service Manual page 527

10. SERVICE MODE
H. Sub Compile CD width adjustment
Adjusts the alignment width of the inside pages when
aligning in the main scan direction.
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3. A sub menu appears on the right side of the
screen.
Press the [07 Perfect Binder Adjustment] key
on the sub menu.
4. "Perfect Binder adjustment mode menu screen"
Press the [08 Sub Compile CD Width Adjust-
ment] key.
5.
"Sub Compile CD Width Adj. screen"
Press [Next] or [Back] key to select the paper
size from the following options.
All Size
8.5 x 11
A4
B5
A5
5.5 x 8.5
16K
A4W
B5W
A5W
8.5 x 11W
5.5 x 8.5 W
Special
Note
• Above paper sizes are book (the inside
pages) finished sizes.
6.
"Sub Compile CD Width Adj. screen"
Enter a value through the numeric keys and press
the [Set] key.
• Setting range:-20 (wider) to +20 (narrower)
1 step = 0.1mm
7. Create multiple books in normal copy mode,
and check the alignment of the second and
later book. Change set value set in Step 5 until
an properly aligned book is created.
492
2
Field Service Ver3.0 Nov.2006
I. Clamp CD width adjustment
Adjusts the alignment width of the inside pages when
aligning in the main scanning direction.
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3. A sub menu appears on the right side of the
screen.
Press the [07 Perfect Binder Adjustment] key
on the sub menu.
4. "Perfect Binder adjustment mode menu screen"
Press the [09 Clamp CD Width Adjustment]
key.
5.
"Clamp CD Width Adj. screen"
Press [Next] or [Back] key to select the paper size
from the following options.
All Size
8.5 x 11
A4
B5
A5
5.5 x 8.5
16K
A4W
B5W
A5W
8.5 x 11W
5.5 x 8.5 W
Special
Note
• Above paper sizes are book (the inside
pages) finished sizes.
6.
"Clamp CD Width Adj. screen"
Enter a value through the numeric keys and press
the [Set] key.
• Setting range:-20 (wider) to +20 (narrower)
1 step = 0.1mm
7. Create multiple books in normal copy mode,
and check the alignment of the second and
later book. Change set value set in Step 5 until
an properly aligned book is created.