Konica Minolta bizhub PRO 1050 Service Manual page 526

Field Service Ver3.0 Nov.2006
G. Temperature adjustment
Sets the temperatures to be detected by the glue
apply roller temperature sensor (TH1), the glue tank
temperature sensor/Up (TH2), the glue tank tempera-
ture sensor/Md (TH3), and the glue tank temperature
sensor/Lw (TH4) provided in the glue tank.
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3. A sub menu appears on the right side of the
screen.
Press the [07 Perfect Binder Adjustment] key
on the sub menu.
4. "Perfect Binder
screen"
Press the [07 Temperature Adjustment] key.
5. "Temperature Adjustment screen"
Press the [COPY] key.
6. Select the paper type and press the start but-
ton to make test prints and carry out perfect
binding.
7. Check that the glue applied has dried appropri-
ately.
8.
To adjust the dryness of the glue, press the
[SERVICE] key.
9.
"Temperature Adjustment screen"
Press the [NEXT] or the [Back] key to select the
option of which the temperature is set.
The following options are provided.
Melt Tank - Top
Melt Tank - Mid
Melt Tank - Low
Pasting Roller
adjustment mode menu
10. Enter a value through the numeric keys and
press the [Set] key.
• Melt Tank - Top
Setting range: 10 to 200 °C
Default: 132 °C
• Melt Tank - Mid
Setting range: 140 to 200 °C
Default: 145 °C
• Melt Tank - Low
Setting range: 140 to 200°C
Default: 185 °C
• Pasting Roller
Setting range: 140 to 200 °C
Default: 165 °C
11.
Repeat the steps 5 to 10 until an appropriate
value is obtained.
10. SERVICE MODE
491
2