Saddle Stitcher Adjustment - Konica Minolta bizhub PRO 1050 Service Manual

Field Service Ver3.0 Nov.2006
B. Paper length adjustment
Conduct this adjustment when a paper exit mis-align-
ment occurs in the sub scan direction of the stacker
tray.
This adjusts the position of the leading edge stopper.
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3.
A sub menu appears on the right side of the
screen.
Press the [05 Stacker Adjustment] key on the
sub menu.
4.
"Stacker Adjustment Mode Menu screen"
Press the [02 Paper Length Adjustment] key.
5. "Paper Length Adjustment screen"
Press the [COPY] key.
6.
Select A3 or 11 x 17 paper and press the start
button to output the test pattern (No. 16).
7.
When a paper exit mis-alignment occurs, press
the [SERVICE] key.
8. "Paper Length Adjustment screen"
Press the [Next] or [Back] key to select either
the stacker 1 or the stacker 2.
9.
Enter a value through the numeric keys and
press the [Set] key.
• Setting range:-20 (narrow) to +20 (wide)
1 step: 0.1 mm
10. Repeat the steps 5 to 9 until an appropriate
value is obtained.

10.13.6 Saddle stitcher adjustment

Conduct various adjustment related to SD
A. Stapling center position adjustment
Adjust the center position of the staple for the saddle
stitching mode.
Broschürenfinisher SD-501
(1) Procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [11 Finisher Adjustment] key.
3. A sub menu appears on the right side of the screen.
Press the [06 Saddle Stitcher Adj.] key on the
sub menu.
4.
"Saddle Stitcher Adjustment Menu screen"
Press the [01 Staple Center Adjustment] key.
5. "Stapling Center Position Adjustment screen"
Press the [COPY] key.
6.
Select A3 or 11 x 17 paper and press the start
button to output the test pattern (No. 16).
7.
Check the misalignment between the staple-
center and the paper center.
• Standard value: a = ± 2 mm
[2]
a
[1] Single fold
8. When the value is not within the standard value,
press the [SERVICE] key.
9.
"Stapling Center Position Adjustment screen"
Enter a value through the numeric keys and
press the [Set] key.
• Setting range:-20 (right) to +20 (left)
1 step = 0.1 mm
10.
Repeat steps 5 to 9 until the standard value
can be obtained.
10. SERVICE MODE
[1]
fs503fs3300c
[2] Stapling center
481
1