Konica Minolta bizhub PRO 1050 Service Manual page 376

10. SERVICE MODE
8. "ADF Centering Sensor Adj. (A4) screen"
Press the [Start] key. Sensitivity of the sensor is
adjusted, and message of completion is dis-
played.
9. Press the [Next] key to select "ADF Centering
Sensor Adj. (8.5 x 11)."
10.
Remove one screw [1] to place the sensor
mounting plate [2] to the "LT" side [3] impress,
the two locating projections [4] to their places.
[3]
[4]
11. "ADF Centering Sensor Adj. (8.5 x 11) screen"
Press the [Start] key. Sensitivity of the sensor is
adjusted, and message of completion is dis-
played.
12. Replace the sensor plate to the position of orig-
inal size (A4 or 8.5 x 11) that the customer
mainly uses.
344
1
[2]
[1]
1050fs3024c
Field Service Ver3.0 Nov.2006
10.3.8 Recall standard data
Reset the adjustment values of the machine adjust-
ment to the factory initial data or the installation initial
Info HJG:
data.
Rücksetzung auf Werks- / oder
Inst. Justagedaten
A. Procedure
1. Enter the service mode.
2. "Service mode menu screen"
Press the [01 Machine Adjustment] key.
3.
A sub menu appears on the right side of the
screen.
Press the [08 Recall Standard Data] on the sub
menu.
4.
"Recall standard data (Machine adjustment)
screen"
Press the [Factory Initial Data] or the [Installa-
tion Initial Data] key.
Note
• Selecting [Factory initial data] recalls the
factory initial data.
• Selecting [Installation initial data] recalls
the adjustment values stored when code
"91" of the I/O check mode was conducted.
• When selecting [Data at shipment] or [Data
at installation], the data returns with no dis-
play changed on the screen.
Info HJG:
Erfolgte Änderung im Speicher sichern
Servicemode
04 Machine condition
01 I/O check Mode
Eingabe "9" u. "1" <091-00>
(siehe untere Info)