Konica Minolta bizhub PRO 1050 Service Manual page 222

3. PERIODIC CHECK
T. Removing/reinstalling the thermostat /2
NOTE
• Be sure to make the position adjustments when the roller has cooled down.
• When reinstalling the thermostat /2, adjust it with the thermostat positioning jig /B before fixing it.
Be sure to apply Screw-lock to the screw that has been fixed.
• After completion of the reinstallation of the thermostat /2, be sure to check the wiring harness to
see if it is in touch with the fusing heating roller.
(1) Procedure for removal
190
[1]
[3]
[2]
1050fs2214c
Field Service Ver3.0 Nov.2006
1.
Pull out the ADU from the main
2. Remove the fusing section.
3.
Open the fusing heating roller assembly.
(See P.165)
4. Remove 2 faston terminals [1].
5.
Remove the screw [2] and then remove the ther-
mostat /2 [3].
NOTE
• For method for reinstalling the thermostat /2,
see "(2) Procedure for reinstallation."
body.(See P.112)
(See P.156)