Konica Minolta bizhub PRO 1050 Service Manual page 233

Field Service Ver3.0 Nov.2006
Step
5 Click "E-Mail Initial Setting" to display the screen for setting.
Set item
Enable E-mail
notification
Time difference
Sending mail
(SMTP) server
SMTP port
number
Sending mail
(SMTP) server
time out
Interval between
fetching mails
Receiving mail
server
Kind of mail
spool
Pop3 (IMAP)
port number
Operating instructions
When using the mail remote notification system, select "Use." Default is "Not
use."
The time at which a mail was send out is calculated based on this value. For
time difference setting, enter the difference from the standard time UTC in the
range from -1200 (- 12 hour 00 minute) to +1200 (-12 hour 00 minute). When
no value is entered, +0000 (UTC) is set. (Ex.: In the case of Japan, enter +
900.)
Set the IP address of the SMTP server.
Set the port No. of the SMTP server. For default, 25 is set.
For SMTP default, 5-minute is set.
The copier check the receiving mail server to see if a mail is newly received.
(An interval can be specified in the range from 1 minute to 60 minutes.) Taking
into consideration the load on the network, this is usually set at the interval of
10 minutes.
Set the IP address of the incoming mail server.
Select either of POP3 and IMAP. For default, [POP3] is selected.
When 110 is used for POP3 and 143 is used for IMAP, select "Use the default
value." When any value other than the default, select "Setting" and enter a
port number to be used in the text box.
Details
4. SERVICE
201
2