Konica Minolta bizhub PRO 1050 Service Manual page 110

3. PERIODIC CHECK
D. Replacing the toner guide brush/scattering prevention felt/seal plate
NOTE
• Be sure to avoid touching the edge of the cleaning blade with bare hands.
• When reinstalling the toner guide brush, apply setting powder uniformly with the toner guide brush
removed.
• Be absolutely sure to avoid touching the brush section of the toner guide brush with bare hands.
Also, be careful that the brush section does not come in direct contact with other objects.
(1) Periodically replaced parts/cycle
• Toner guide brush: Every 1,500,000 prints
• Scattering prevention felt: Every 1,500,000 prints
• Seal plate /Fr: Every 1,500,000 prints
• Seal plate /Rr: Every 1,500,000 prints
(2) Procedure
78
[2]
[1]
[4]
[3]
1050fs2118c
Field Service Ver3.0 Nov.2006
1.
Pull the photo conductor section out of the main
body. (See P.38)
2.
Remove the cleaning section.
3. Remove the toner seal
4. Remove the screw [1] and then remove the seal
plate /Fr [2].
5. Remove the screw [3] and then remove the seal
plate /Rr [4].
(See P.72)
board.(See P.77)