Software Dipsw Setting For Cs Remote Care - Konica Minolta bizhub PRO 1050 Service Manual

Field Service Ver3.0 Nov.2006
H. E-Mail initial setting
1.
"E-Mail Setting Menu screen"
Press the [01 Basic setting] key.
2.
"Basic setting screen"
Press the [Center No.] key.
3. Enter the center ID with the keyboard, and
press the [OK] key.
4.
Press the [OK] key to return to the "E-Mail Set-
ting Menu screen."
5.
"E-Mail Setting Menu screen"
Press the [03 Response time out setting] key. *
6. Enter the response time out time with the
numeric keys. (in minutes)
7.
Press the [OK] key to return to the "E-Mail Set-
ting Menu screen."
NOTE
• The response time out setting is automati-
cally set on receiving the initial connection
mail. Change the setting if necessary.
10.11.5 Software DIPSW setting for CS Remote
Care
NOTE
• DIPSW bits data are written into the Parame-
ter board (PB) every time a change is made.
In case you changed bit data by accident, be
sure to restore the previous state.
A. Input procedure
1.
Enter the service mode.
2.
"Service mode menu screen"
Press the [09 CS Remote Care] key.
3.
"Sub menu screen"
Press the [01 CS Remote Care] key.
4. "CS Remote Care setting screen"
Press the [No. Code] key.
5.
Use the sheet setting keys to enter the No.
code. *1
6.
Press the [No. Code] key.
7.
Press the [Detail setting] key.
8.
"Setting menu screen"
Press the [05 Software SW Setting] key.
9. "Software SW Setting screen"
Select the DIPSW number.
Use the left arrow key or the numeric keys.
10.
Select the DIPSW bit number.
Use the right arrow key or the numeric keys.
11. Select DIPSW On (1), Off (0).
Use the [On (1)], [Off (0)] key.
12.
Press the [Return] key to return to the "Setting
menu screen."
*1 If the No. code is already entered, confirm that
No. code.
NOTE
• About functions of each switch, see to
List of software DIPSW for CS Remote
10. SERVICE MODE
"B.
Care".
457