Konica Minolta bizhub PRO 1050 Service Manual page 108

3. PERIODIC CHECK
[1]
76
[2]
fs503fs2153c
Field Service Ver3.0 Nov.2006
11. Reinstall the parts after that following the removal
steps in reverse.
NOTE
• After replacing the cleaning blades /1 and /2,
be sure to check to see if the blade replace-
ment lever [1] has been pulled.
• After replacing the cleaning blades /1 and /2,
be sure to conduct the blade set mode in the
service mode to prevent the blade from curl-
ing up.(See P.346)
• Be sure to avoid using the blade set mode
other than when replacing the cleaning blade.
Otherwise, the cleaning blade count of the
fixed parts count is reset so that the blade is
not replaced automatically at the correct tim-
ing.