Iii Adjustment/Setting; Checking The External Interface Operation Mode Setting; Setting For Pagescope Remote Care; Setting Procedures - Konica Minolta bizhub C350 Service Manual

Standard Controller Field Service Ver2.0 Sep. 2004 Checking the external interface operation

III Adjustment/Setting

1.

Checking the external interface operation mode setting

• Whenever the controller is mounted, it is necessary to select "Controller 3" in "Peripheral
Setting."
1. Call the Tech. Rep. Mode to the screen.
2. Touch "System Input".
3. Check that "Controller 3" is selected in "Peripheral Setting."
NOTE
• If the mode is changed, be sure to turn OFF and ON the Power Switch. The change
of the setting becomes valid when the Power Switch is turned OFF and ON after
the appropriate change has been made on the panel.
2.

Setting for PageScope Remote Care

• Be sure to make the following settings to use PageScope Remote Care. After the set-
tings have been made, establish a connection with the PageScope Remote Care Device
Management Server.
2.1

Setting procedures

Follow these procedures to make the settings.
1. In the Tech. Rep. mode accessed from the machine control panel, check that "e-mail" is
selected in "RD Mode".
2. Select "System Input" - "Peripheral Setting" - "Server Set (RD)" from the Tech. Rep.
mode and make the e-mail transmission/reception settings.
"Server Set (RD)" will not be displayed unless "Controller 3" has been selected in
"Peripheral Setting".
3. In "TX/RX Test", check the e-mail transmission/reception settings.
Obtain the following information from the network administrator in advance.
• IP addresses of mail servers (POP3 and SMTP)
• Logon user name and password set for the controller
• Mail domain name
• POP3 port number of the mail server (ordinarily, 110)
• SMTP port number of the mail server (ordinarily, 25)
2.2

"Server Set (RD)" settings

• To use PageScope Remote Care, it is necessary to make the e-mail reception settings
and e-mail transmission settings.
2.2.1

E-mail reception settings

• These settings may be the same as, or different from, the mail reception settings for
Internet Fax.
1. Touch "Server for RX".
2. Touch "POP3 Server" and type the IP address of the reception mail server.
3. Touch "POP3 login Name" and type the logon user name.
4. Touch "POP3 password" and type the logon password.
5. Touch "POP3 port number" and type the port number to be specified when connecting
with the POP3 server. Ordinarily, type 110.
3-1