Traction Pedal, Cable, And Control Assembly - Toro Groundmaster Series Service Manual

Traction Pedal, Cable, and Control Assembly

g302086
1. Pad – forward
2. Pad – reverse
3. Plastic washer (2 each)
4. Pedal hub
5. Roll pin
6. Lock nut (2 each)
7. Carriage bolt (12 each)
8. Pedal bracket
9. Bearing (2 each)
10. Flange nut (12 each)
11. Cap screw (2 each)
12. Neutral switch
Removing and Installing the Traction Control Components
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
13. Jam nut (2 each)
14. Lock washer (2 each)
15. Lock nut
16. Support bracket
17. Damper
18. Pump lever
19. Pinch bolt
20. Cap screw (2 each)
21. Cap screw
22. Ball joint (2 each)
23. Spacer – 5 mm (0.21 inch)
24. Traction cable
Remove and install the traction control components as necessary.
1. Apply anti-seize lubricant to the traction pedal shaft during assembly.
2. If the traction cable is being replaced:
A. Install the ball joints on the cable ends at the location shown; refer to
Figure 116.
Figure 115
25.
26.
27.
28.
29.
30.
31.
32.
33.
34.
35.
Page 7–11
Clamp
Socket head screw (2 each)
Spacer – 9 mm (0.35 inch)
Washer (2 each)
Washer (2 each)
Cable bracket
Lock nut (2 each)
Pedal stop bolt
Traction pedal
Roll pin
Forward pedal
Chassis: Service and Repairs