Operator's Console - Toro Groundmaster Series Service Manual

Operator's Console

g304808
1. Swell latch (2 each)
2. Access cover
3. Cap screw (10 each)
Removing and Installing the Operator's Console Covers
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
(models 31900 and 31901 shown)
4. Screw
5. Cover – right side
6. Cover – left side
Refer to Figure 123 for this procedure.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
the key from the key switch.
2. Remove the access panel from the right side of the operator's console.
3. Remove the long screw at the front of the console near the TDM
display/controller screen (item 4).
4. Remove the remaining fasteners and the console covers if necessary.
5. Install the console covers in the reverse order.
Figure 123
Page 7–23
7. Nut
position and remove
FF
Chassis: Service and Repairs