Toro Groundmaster Series Service Manual page 303

Servicing the Blade Spindle (Groundsmaster Series Cutting Units)
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
g315871
1. Spindle housing
2. Grease fitting
3. Locknut
4. Hardened washer
5. Pulley
6. Spindle shaft
7. Spindle spacer
8. Seal (2 each)
Blade spindles for Groundsmaster series cutting units have cast iron spindle
housings, greasable roller bearings, 31.7 mm (1.25 inch) spindle shafts, anti
scalp cups, and are designed to use 6.3 mm (0.25 inch) thick blades.
Disassembling the Blade Spindle
Refer to Figure 135 for this procedure.
Figure 135
9. O-ring
10. Bearing cone (2 each)
11. Bearing cup (2 each)
12. Spacer ring
13. Large snap ring
14. Inner bearing spacer
15. Outer bearing spacer
16. Drive Stud (8 each)
Page 8–11 Cutting Units: Service and Repairs