Toro Groundmaster Series Service Manual page 83

Removing the Engine (continued)
Installing the Engine
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
11. Connect a suitable hoist or lift to the front and rear lift tabs on the engine. On
model 31902 and 31903 machines, do not allow the lift chains or straps to
contact the DPF.
12. Remove the 3 lock nuts, snubbing washers, spacers and cap screws
securing the engine mounts to the engine brackets.
Use 1 person to operate the lift or hoist while the other person
guides the engine from the machine.
When removing the engine ensure that you do not damage the
engine, fuel hoses, hydraulic lines, electrical harnesses or other
parts.
13. Carefully raise the engine from the machine moving it toward the rear of
the machine.
14. Check the condition of the motor mounts and replace if necessary. Ensure
that the battery negative (-) cable is secured to one of the front left motor
mount fasteners.
15. Continue to disassemble the engine if necessary.
16. Cover or plug all engine openings to prevent contaminants from entering
the engine.
Refer to Figure 17 for this procedure.
Ensure that all parts are removed from the engine during
maintenance or overhaul are correctly installed on the engine.
1. If front engine mount brackets were removed from the engine, tighten the
bracket to engine fasteners from 46 to 57 N·m (34 to 42 ft-lb).
2. Apply anti-seize lubricant to the stub shaft before installing the square key
and PTO clutch.
3. Place the pump drive belt in position on the stub shaft.
CAUTION
IMPORTANT
IMPORTANT
Page 4–21 Engine: Service and Repairs