Adjustments; Adjusting The Parking Brake; Adjusting The Traction Cable; Adjusting The Tie Rod Length (Rear Wheel Toe-In) - Toro Groundmaster Series Service Manual

Adjustments

Adjusting the Parking Brake

Adjusting the Traction Cable

Adjusting the Tie Rod Length (Rear Wheel Toe-In)

Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
Refer to the traction unit Operator's Manual for this procedure.
1. Check the traction system for N
Adjusting the Traction System for Neutral (page
2. Loosen the traction pedal stop bolt jam nuts and lower the traction pedal
stop bolt.
3. Depress the traction pedal fully forward. The traction pedal and pedal hub
should not contact the stop bolt or any part of the machine, ensuring the
traction pump is at its full forward displacement. Adjust the traction cable
ball joint slightly if necessary.
4. With the traction pedal fully forward, extend the pedal stop bolt to contact
the traction pedal.
5. Release the traction pedal and extend the pedal stop bolt an additional 1/2
turn before locking the stop bolt in position with the jam nuts.
g314862
1. Tie rod
2. Groove (LH thread end)
3. Rod end – LH thread
1. Check the tie rod assembly length as shown in
Note: One of the tie rod ends and its jam nut have left hand threads. The left
hand threaded components are indicated by a groove near the end of the
tie rod.
2. Loosen the jam nuts and adjust the tie rod length as necessary. Tighten
the jam nuts to 122 N·m (90 ft-lb)..
and adjust if necessary; refer to
EUTRAL
Figure 109
4. Jam nut – LH thread
5. Rod end – RH thread
6. Jam nut – RH thread
Page 7–3
5–50).
Figure 109.
Chassis: Adjustments